Your return vent.
Now with a filter.
A clean white grille. A replaceable activated-carbon filter. Catch dust where room air enters your ductwork.
$36.35per grilleFirst filter included
For horizontal 14″ × 6″ return openings.
Baseboard & sidewall.
One-time purchase · $5.00 replacement pads.
Delivery and tax calculated at checkout.
Right at home.
Two placements. The same thoughtful detail.
Actual installations · For horizontal 14″ × 6″ return openings. Confirm fit before ordering.
A little closer.
A lot clearer.
Open the front. Lift the filter. Explore the original product assembly, then see where it fits into your home's airflow.
A familiar grille.
More inside.
The clean white front fits into your room. The activated-carbon pad sits just behind it.
Check my fitOpen the front.
Reach the filter.
Release the top and bring the front forward. The filter is right there for you to check.
See the installationA fresh filter.
A simple swap.
Lift out the used pad. Put a fresh one in. Keep your Impeccable Air grille.
Shop replacement filtersCompatible return openings.
Baseboard & sidewall.
Works alongside your primary HVAC filter.
Catch it here.
Before it travels there.
Room air reaches your return vent before it reaches your primary filter. Impeccable Air adds filtration at that first opening. Your primary HVAC filter stays in place.
The grille adds a filter where room air enters the duct. It works alongside your primary HVAC filter.
A focused detail of the illustrative three-return system. Use the comparison above to explore both conditions.
Dust enters the ductwork.
Filtered at the return.
Particles pass through unfiltered grilles and enter the return ducts.
Impeccable Air catches dust where room air enters the ducts.
Dust travels with the air.
Your primary filter stays.
Dust coats the duct interiors as the air moves toward the primary filter.
Air continues through the ductwork toward your primary HVAC filter.
Some dust comes back.
The loop continues.
The primary filter catches particles; residual dust continues through the supply vents.
Supply vents carry air back into the rooms.
Illustrative dirty-system and clean-system comparison. Filters do not remove existing duct deposits.
About this illustration
These are separate conceptual conditions, not a before-and-after cleaning sequence. The clean view intentionally omits downstream contamination to emphasize filtration at each return. It does not claim complete particle capture or spotless ducts in an installed system.
The illustrated particles and airflow are not measured capture rates or a prediction of a home’s duct condition. Actual results depend on system compatibility, media, fit, use and maintenance. Keep the primary HVAC filter in place and confirm compatibility before adding filters.
See lab resultsHow does it compare with a standard return grille?
An upgrade to the vent you know
Give your return
a second job.
It already draws room air into your heating and cooling system. Impeccable Air adds a replaceable filter before that air enters the duct.
Your primary HVAC filter stays in place. The added filter sits behind the grille, where you can reach it from the room.
| At the return | Unfiltered return |
The added layerImpeccable Air return |
|---|---|---|
| Where air goes | Room air into the HVAC system |
Room air into the HVAC system |
| Filter at the opening |
No filter at this opening |
Replaceable activated-carbon pad |
| Primary HVAC filter |
Still needed | Still needed |
For compatible horizontal 14″ × 6″ return openings in baseboard or sidewall placements.
$36.35per grille
First filter included
See what your
filter catches.
Compare a fresh black pad with one that has collected visible dust. The difference is right behind the grille.
A filter at the return.
Easy access from the room.
Filtration,
put to the test.
See how the filter performed in controlled chamber testing. Explore the results, the test conditions, and the full report.
See lab resultsEngineering Laboratories
Particle and selected-gas studies, with filter and control conditions.
Chamber results describe the tested setup. They are not single-pass filter efficiency or a guarantee of results in your home. System design, fit, runtime and filter condition matter.
Open.
Replace.
Close.
The removable front keeps the filter within reach. Watch the filter change, or choose the installation guide for your grille.
Fresh filters. Simple upkeep.
Keep the grille.Refresh the filter.
Fresh activated-carbon pads are pre-cut for your grille and ready for the next filter change.
The activated-carbon replacement pad
- Start with a grille
- $36.35per grille
- First filter pad included
- Refresh with a pad
- $5.00per replacement pad
- Order as you need them
Inspect around every 90 days. Replace as needed. Household conditions and system runtime affect how often a filter needs changing.
Sold individually. No subscription required.
A great fit starts
behind the grille.
Three checks. One confident choice.
- A return ventAir draws in, rather than blowing out.
- A horizontal 14″ × 6″ openingMeasure the opening behind the existing cover.
- Baseboard or sidewallConfirm each opening you're ordering for.
Keep your primary HVAC filter. Not for supply vents or ceiling installation.
Width first. Then height.
What owners notice.
HomeDepot.com customers share their experiences with installation and everyday use.
“The install is very easy and I can’t understand why filtered home air isn’t the norm.”
“After 60 days of installation, we were stunned at all the dust the filter captured!”
“Easy to install and maintenance will be a breeze!!!!”
Individual experiences; not measurements of household air quality.
Questions before
you order?
Get clear on fit, filter changes, shipping, and returns.
Ask us a questionWhat is a return vent?
A return draws room air back into your heating and cooling system. With the system fan running, hold a tissue near the vent: air pulling the tissue toward it indicates a return. Supply vents blow air into the room and are not suitable for this product.
What size do I need?
The current grille is for an exact horizontal 14″ wide × 6″ high return-duct opening in a supported baseboard or sidewall position. Measure the opening behind the old grille, not its outside face. If your size differs, send us a photo and your measurements before ordering.
Does this replace the filter at my furnace?
Keep your primary HVAC filter in place. Impeccable Air adds filtration at a compatible return opening, before that air enters the return duct. Confirm compatibility with your HVAC system before adding filters.
What comes with my grille?
Each grille includes its first activated-carbon filter pad. Replacement pads are $5.00 each. Choose the correct baseboard or sidewall option and follow its installation instructions.
How often should I change the filter?
Inspect around every 90 days, and replace as needed. Household conditions, HVAC runtime and filter condition affect how quickly a pad needs changing. Follow your system’s maintenance requirements.
How do shipping and returns work?
Orders are processed and shipped within 1 business day; carrier transit time is additional. Delivery and tax are calculated at checkout. Request unused, uninstalled returns within 30 days of delivery, in original packaging with included items. No restocking fee; unused-return shipping is customer-paid and original shipping is nonrefundable.
Ready to upgrade
your return?
Check your opening. Choose your grille.
$36.35 per grille · First filter included.